U.S. home repair cost reference30 guides

Know what a home repair should cost before you call a contractor.

Typical price ranges for 30 roofing, HVAC and plumbing jobs, built from published cost data and federal wage statistics, with the sources listed on every guide.

Most read:Roof ReplacementWater Heater ReplacementAC Unit ReplacementFurnace Repair

Updated

Quick cost lookup

What will my project cost?

Add a ZIP code to adjust the labor share for your area.

Typical range, U.S. national
$7,500 – $14,000

National average $10,000

Planning estimate from published price data, not a quote. A ZIP adjusts only the labor share, using BLS wage data.

At a glance

The most-searched home repair costs

U.S. typical ranges and averages from each guide. The bar runs from the low end to the high end; green is the typical range, the tick is the average.

Installed project cost unless a unit is shown. Planning estimates, not quotes; how the ranges are built.
ProjectTypical rangeAverageRange from low end to high end
Water Heater Replacement CostPlumbing$882 – $1,826$1,348Angi average
AC Compressor Replacement CostHVAC$800 – $2,800$1,550Average reported by both This Old House and Fixr
Roof Replacement CostRoofing$7,500 – $14,000$10,000
Furnace Repair CostHVAC$150 – $600$375Midpoint of Fixr's $350 to $400 national average
Sewer Line Repair CostPlumbing$1,100 – $4,100$2,600Angi average
AC Unit Replacement CostHVAC$5,500 – $10,000$7,750Midpoint of Fixr's range
Furnace Replacement CostHVAC$2,800 – $7,500$4,800
Roof Repair CostRoofing$400 – $1,900$1,150
Gas Line Installation CostPlumbing$260 – $820$540Midpoint of Angi's range
Heat Pump Replacement & Installation CostHVAC$5,000 – $15,000$8,350

Common decisions

Start with the guide for your situation

Many repair decisions come down to fixing one part or replacing the whole system, or to a full installation versus labor only. Each pair links the two guides to compare; the typical ranges are read from each guide.

Browse by trade

Cost guides by category

8 guides

Roofing cost guides

New roofs by size and material, repairs by problem, shingle labor per square, metal, tear-off and decking.

All 8 roofing cost guides

10 guides

HVAC cost guides

Central air, compressors and coils, furnace repair and replacement, heat pumps, mini-splits and ductwork.

All 10 HVAC cost guides

12 guides

Plumbing cost guides

Water heaters (tank, gas, tankless, labor only), sewer and water lines, septic, gas lines and fixtures.

All 12 plumbing cost guides

How the figures are built

Published prices, named sources

Each range is compared with the cost publishers it cites. Where a figure is our planning estimate or a calculation, the guide says so, and corrections are dated in each guide's change log.

MethodologyEditorial standardsAll sources

Sources
142source pages from 20 publishers cited by the guides: cost publishers such as Fixr, This Old House and Angi / HomeAdvisor (one company), plus BLS wage data and government references.
Local labor
BLSA ZIP code adjusts only the labor share, using May 2025 state and metro wages for each trade.
Prepared by
Repair Cost Atlas Editorial TeamResearchers and editors, not contractors. The guides are credited to the team; the about page explains who runs the site and how it is funded.

Change log

Recent corrections and updates

What changed in the guides and when, from each guide's change log. See the full corrections log.

  1. AC Compressor Replacement CostTypical range now Fixr's published $800 to $2,800 with the $1,550 average reported by Fixr and This Old House. The compressor part now shows Fixr's full $400 to $1,800, labor uses Fixr's $600 to $1,200 labor-and-refrigerant figure, refrigerant is $50 to $120 per pound across Fixr's pages, and unpublished permit and disposal allowances were removed. Added answers on failure signs, job length, repairing R-410A and R-22 systems, and timing.
  2. AC Unit Replacement CostTypical range now Fixr's published $5,500 to $10,000 for a 3-ton replacement on existing ducts (average shown is its midpoint); the earlier $4,800 to $9,500 band and $3,500 low end were not published by any source. Confidence lowered to medium. Fixr's repair-or-replace rule corrected, SEER cards show SEER2, and new answers cover refrigerants (R-454B, R-32, R-22), signs, job length, permits and the best time to replace.
  3. Air Duct Cleaning CostHigh end raised to This Old House's $1,200 for a 3,000 sq ft home. Add-on prices that Angi's data does not contain were replaced with Fixr's published figures (dryer vent about $140, mold remediation $1,000 to $5,000) or removed (furnace cleaning, duct coating, a permit fee). Size rows now use Fixr's published table. Added EPA's advice that ducts be cleaned only when needed, and answers on warning signs and how long cleaning takes.
  4. Air Duct Replacement CostOne price for the average home: typical range now Angi's published $2,000 to $4,500 for a 2,000 sq ft home, with an average of $3,400 labelled as the midpoint of This Old House's 200-foot price. The unpublished $1,800 and $1,200 figures were removed; the high end is This Old House's 500-foot price ($9,300), now shown as a row. Labor rate corrected to Fixr's $75 to $200 per hour. Added answers on signs, job length, insurance and permits.
  5. Asphalt Shingle Roof Replacement CostTypical range and average re-based on Fixr's published $8,000 to $16,000 and $12,000; the previous $6,000 to $15,000 and $9,800 were not published by any source, and the claim that published averages bracket them was false. One price per roof size (architectural shingles at Fixr's $4 to $8 per sq ft). New labor section with published per-square, per-sq-ft and hourly prices; overlay answer re-sourced and unsupported code and warranty claims removed.
  6. Evaporator Coil Replacement CostCorrected two misattributed figures: the $800 "condenser coil" price was Angi's uncased evaporator coil, and a $850 3-ton coil price was not in Angi's data. Angi and HomeAdvisor are now presented as one source. Added This Old House's evaporator coil prices and answers on failure signs, refrigerant compatibility (R-410A, R-454B, R-32, R-22) and timing.

Repair Cost Atlas is not a contractor marketplace, dispatch service or lead broker, and it does not provide contractor bids. The ranges are for planning and for checking written, itemized quotes.